Recycling sewage sludge into ceramic materials: A review

Environmental Chemistry Letters - Huge amounts of unwanted sewage sludge are generated in the process of wastewater treatment, calling for methods to recycle sewage sludges into value-added...     

夏热冬冷地区屋顶绿化全年能耗削减及成本效益

绿化屋顶的降温节能效益已有诸多文献报导,但专门针对夏热冬冷地区不同屋顶绿化模式的全年能耗模拟研究并不多见.以南京为例,采用EnergyPlus模型分析粗放、半密集、密集3类典型屋顶绿化的全年建筑能耗削减效应及季节规律,基于降温节能价值开展成本效益分析.结果 表明,屋顶绿化能够通过蒸散与隔离作用调节建筑屋顶表面温度,夏季以降温为主,最大降温幅度为29.3℃,冬季以保温为主,最高升温幅度为13℃.夏冬两季屋顶表面温度的降低/升高分别引起建筑制冷/热负荷的削减:粗放、半密集、密集3种绿化屋顶夏季制冷负荷削减率分别为-0.4％、2％和2.4％,冬季制热负荷分别降低16.5％、23.1％和28.3％,全年建筑能耗削减率为1.9％、4.9％和5.9％,其中,顶层能耗削减占削减总量的11％～71％.成本效益分析结果表明,密集型屋顶绿化的财务净现值最大、投资回报率最高,但3类绿化屋顶在40年生命周期内均无法通过能耗削减效益收回投资成本.研究结果可为同气候区屋顶绿化设计与推广提供参考.     

A combined radical and non-radical oxidation processes for efficient degradation of Acid Orange 7 in the homogeneous Cu(II)/PMS system: important role of chloride

Environmental Science and Pollution Research - Trace copper ion (Cu(II)) in water and wastewater can trigger peroxymonosulfate (PMS) activation to oxidize organic compounds, but it only works under...     

An asymmetric analysis of the impacts of energy use on carbon dioxide emissions in the G7 countries

Environmental Science and Pollution Research - The foremost theme of the paper is to explore the asymmetric/symmetric impact of energy consumption on the carbon dioxide emission of G7 countries...     

Understanding and addressing the environmental risk of microplastics

Over the past decades, the plastic production has been dramatically increased. Indeed, a category of small plastic particles mainly with the shapes of fragments, fibers, or spheres, called microplastics (particles smaller than 5 mm) and nanoplastics (particles smaller than 1 μm) have attracted particular attention. Because of its wide distribution in the environment and potential adverse effects to animal and human, microplastic pollution has been reported as a serious environment problem receiving increased attention in recent years. As one of the commonly detected emerging contaminants in the environment, recent evidence indicates that the concentration of microplastics show an increasing trend, for the reason that up to 12.7 million metric tons of plastic litter is released into aquatic environment from land-based sources each year. Furthermore, microplastic exposure levels of model organisms in laboratory studies are usually several orders of magnitude higher than those found in environment, and the microplastics exposure conditions are also different with those observed in the environment. Additionally, the detection of microplastics in feces indicates that they can be excreted out of the bodies of animal and human. Hence, great uncertainties might exist in microplastics exposure and health risk assessment based on current studies, which might be exaggerated. Policies reduce microplastic emission sources and hence minimize their environmental risks are determined. To promote the above policies, we must first overcome the technical obstacles of detecting microplastics in various samples.     

氨废水资源化利用的折流式超重力床集成技术

利用折流式超重力床将氨废水处理的精馏和吸收过程集成在一台设备中,开发出一种设备小型化、流程紧凑的氨废水资源化利用集成技术。与传统技术相比,该技术在大幅节省占地面积和空间的同时,还可大幅节约设备建设所用钢材。工业规模试验结果表明,不同浓度的氨废水经该技术处理后可转化为氨质量分数大于22%的氨水资源,处理出水中氨氮质量浓度低于8.2 mg/L,尾气中未检测到氨,处理结果优于GB 31573—2015《无机化学工业污染物排放标准》。     

地铁区间隧道烟气层化现象研究

以重庆某一地铁区间隧道为原型,搭建了1∶15小尺寸隧道试验台,通过小尺寸试验与FDS 6.5.2数值模拟开展隧道顶部烟气温度分布及分层规律研究。基于Newman提出的烟气层分区条件,研究了不同纵向风速下的烟气分层现象,提出了烟气稳定层化长度的概念,并分析了火源热释放速率及断面型式对烟气层化长度的影响。试验证明了Newman提出的烟气分层计算方法是可信的。结果表明:纵向风速较小时,火源下游能呈现烟气分层现象;烟气稳定层化长度受火源热释放速率影响较大,随热释放速率增大而增大;隧道高度的变化对烟气稳定层化长度的影响较小。     

常州市春节期间污染物相关性分析

分析了常州市2017年春节前后各污染物浓度的关联性和差异性。结果表明,除O_3外,春节期间各污染物均值均低于春节前后,春节前后随着污染源的变化,污染物之间的相关性表现出较为明显的差异。SO_2与PM_(2.5)、PM_(10)、CO和NO_2的相关性均较春节前后有显著下降;爆竹集中燃放时间段,CO与综合指数、PM_(2.5)和PM_(10)之间的相关系数0.96;而在烟花爆竹燃放相对较少的初三和初四,该相关系数0.6。工业减产停产和机动车使用减少对空气质量改善有较大贡献,而在不利气象条件下,烟花爆竹可导致空气质量在短时间内恶化。     

Carbon Emission from the Surface of Coarse Woody Debris in Korean Pine Forests of Southern Primorye

Carbon dioxide fluxes from the surface of coarse woody debris (CWD) have been measured in Korean pine forests of the southern Sikhote-Alin mountain range. The seasonal dynamics of oxidative conversion of CWD carbon have been evaluated, and average values of the CO₂ emission rate have been determined for CWD fragments of three tree species at different stages of decomposition. The degree of decomposition is an important factor of spatial variation in CO₂ emission rate, and temporal variation in this parameter is adequately described by an exponential function of both CWD temperature and air temperature (R² = 0.65–0.75).     

Heat dissipation characteristic in the intake grille and radiator of a fuel cell vehicle

ABSTRACT

In this study, a three-dimension (3D) computational model was proposed to investigate the flow and heat transfer characteristics of the intake grilles of two different fuel cell vehicles. The models of the intake grilles were constructed according to the actual sizes of two vehicles, namely, Roewe 950 and Toyota Mirai, considering the heat dissipation unit to simplify the heat transfer model of the vehicle. The results showed that relative to Roewe 950, Mirai intake air flow rate was approximately 10% higher, the heat transfer capacity was approximately 7% higher, and the intake grille area was larger. The coolant outlet temperature of Mirai was lower than that of Roewe 950, which was beneficial for the long term and stable operation of a fuel cell. This comparative study provided guidance for the intake grille and radiator design of fuel cell vehicles. The only difference between fuel cell vehicles on the market and conventional vehicles was that in the former, the internal combustion engine was replaced with a fuel cell stack, which had insufficient heat transfer capacity because of the reducing temperature difference. Increasing the intake grille area and the heat exchange capacity of the radiator were the key issues for the development of fuel cell vehicles. In this study, an optimal window opening angle of the radiator fin of 23° provided a maximal heat transfer coefficient.